664T Home WAN Settings
WAN Settings are settings that are used to connect to your ISP. These settings may be referred to as Public settings. These settings are provided to you by your ISP. Please select the appropriate option to connect to your ISP.
PVC - Leave the set at the default value 0 the first time the Router is set up. For more information on this option see Multiple PVC Operation.
VPI - If instructed to change this, type in the VPI value for the initial connection (using PVC 0). Default= 8.
VCI - If instructed to change this, type in the VCI value for the initial connection (using PVC 0). Default= 35.
Virtual Circuit - The Virtual Circuit over which this PPP data is sent. The VC identifies the physical path the data takes to reach your ISP.
Service Category - Select the ATM service category.
PCR - Enter the ATM PCR value.
SCR - Enter the ATM SCR value.
WAN - Dynamic IP Address
Select this option if your ISP provides you an IP address automatically. This option is typically used for Cable services. Please enter the Dynamic IP information accordingly.
WAN - Static IP Address
Select this option to set static IP information. You will need to enter in the Connection type, IP address, subnet mask, gateway address, and DNS address(es) provided to you by your ISP. Each IP address entered in the fields must be in the appropriate IP form, which is four IP octets separated by a dot (x.x.x.x). The Router will not accept the IP address if it is not in this format. Example: 192.168.0.100
WAN - PPPoE/PPPoA
Select this option if your ISP requires you to use a PPPoA/PPPoE connection. This option is typically used for DSL services. Select PPPoA/PPPoE to obtain an IP address automatically for your PPPoA/PPPoE connection. Please enter the information accordingly.
WAN - Bridge Mode
The modem can be configured to act as a bridging device between your LAN and your ISP. Bridges are devices that enable two or more networks to communicate as if they are two segments of the same physical LAN. Please set the Connection type.